DELRAY Systems
0

UltiMaker CPE+

$69.95

Certified NFC Ultimaker Material

CPE (co-polyester) materials are chemical resistant, tough, and demonstrate good dimensional stability. UltiMaker CPE+ is a preferred choice for both functional prototypes and mechanical parts. While both CPE and CPE+ provide similar performance characteristics, CPE+ provides the added benefit of higher temperature resistance and increased impact strength. Product designers use CPE+ to make extremely tough and dimensionally stable functional prototypes.



Add to Cart
UltiMaker CPE+
UltiMaker CPE+
Product Details
Specifications
UltiMaker CPE+
  • Diameter:
    2.85 ± 0.10 mm
  • Max roundness deviation:
    0.10 mm
  • Tensile modulus:
    1,128.5 MPa
  • Tensile stress at yield:
    35.2 MPa
  • Tensile stress at break:
    33 MPa
  • Melt mass-flow rate (MFR):
    8.5 g/10 min
  • Heat detection (at 0.455 MPa):
    94 °C
  • Heat deflection (at 1.82 MPa):
    81 °C
Added to cart
- There was an error adding to cart. Please try again.
Quantity updated
- An error occurred. Please try again later.
Deleted from cart
- Can't delete this product from the cart at the moment. Please try again later.